Sample preparation and determination of biomass content in solid recovered fuels: a comparison of methods.

The biomass content of material from pulp and paper production (a mixture of waste and paper and thin layer packaging plastics) is determined by the adapted balance method. This novel approach is a combination of combustion elemental analysis (CHNSO) and a data reconciliation algorithm based on successive linearisation for evaluation of the analysis results. It also involves less effort and expense than conventional procedures. However, the CHNSO technique only handles small mass amounts (few hundred milligrams), so cryogenic impact milling was applied for particle size reduction below 200 µm in order to generate homogeneous, representative analysis samples. The investigation focuses on the parameters biogenic content as a percentage of the total mass xB and xB (TC), which is the biomass stated as a fraction of the total carbon value. The results are within 1%-5% of the data obtained by the reference methods, namely the selective dissolution method and (14)C- method. Additionally, advantages and drawbacks of the adapted balance method in comparison with standard methods are discussed, showing that the adapted balance method is a method to be considered for the determination of biomass content in solid recovered fuels or similar materials.

Sample preparation and biomass determination of SRF model mixture using cryogenic milling and the adapted balance method.

The biogenic fraction of a simple solid recovered fuel (SRF) mixture (80 wt% printer paper/20 wt% high density polyethylene) is analyzed with the in-house developed adapted balance method (aBM). This fairly new approach is a combination of combustion elemental analysis (CHNS) and a data reconciliation algorithm based on successive linearisation for evaluation of the analysis results. This method shows a great potential as an alternative way to determine the biomass content in SRF. However, the employed analytical technique (CHNS elemental analysis) restricts the probed sample mass to low amounts in the range of a few hundred milligrams. This requires sample comminution to small grain sizes (<200 µm) to generate representative SRF specimen. This is not easily accomplished for certain material mixtures (e.g. SRF with rubber content) by conventional means of sample size reduction. This paper presents a proof of principle investigation of the sample preparation and analysis of an SRF model mixture with the use of cryogenic impact milling (final sample comminution) and the adapted balance method (determination of biomass content). The so derived sample preparation methodology (cutting mills and cryogenic impact milling) shows a better performance in accuracy and precision for the determination of the biomass content than one solely based on cutting mills. The results for the determination of the biogenic fraction are within 1-5% of the data obtained by the reference methods, selective dissolution method (SDM) and (14)C-method ((14)C-M).